|
90#
楼主 |
发表于 2018-9-29 13:18:36
来自手机
|
只看该作者
本帖最后由 liuzhaoyzz 于 2018-10-1 20:20 编辑
You can remove primo program and reboot,then try 3.72 again.
The reason maybe relate to pagefile.sys or hiberfil.sys,You can close them,such as run powercfg -h off command as admin,then reboot.
and the disk where 3.72 lies must have 3 times useable space as big as drive C:'s used space .
Your system is English system.
But I think the batch can run under English or Chinese OS system,it doesn't matter.it is just a prompt.
cannot find disk #0, You can also refer to this post:
新系统用3.72装P驱,总是装不上,求助 - RAMOS - 无忧启动论坛 - Powered by Discuz! http://bbs.wuyou.net/forum.php?m ... p;extra=&page=1
Don't install primo manually,the batch will install it automatically.
X86 system maybe need to enable PAE function.
PAE: bcdedit /set pae forceenable as administrator,then reboot.
|
|