[localimg=400,244]1[/localimg] 由于U盘只能查看，不能写入文件，也不能格式化，所以对它进行了量产。结果量产后更严重，第一次量产设置全是默认设置。
出现的错误代码
0x10 Disk can't be formated as the selected file system
0x11 Disk mounted flash chips doesn't match the setting
0x12 (1)Disk size does't match the setting (2)Disk is zero size (Unknown flash)
0x13 Disk is write-protected
0x14 Mounted flash product ID is not matched
0x28 Run SCSI command Failed
0x41 ISP / CIS blk search Failed
0x42 Build flash LUT Failed
0x44 Bad block count is out of range
0x48 Bad block count exceed tolerance
0x51 Single/Dual channel check Failed
0x54 (1)Firmware version mismatch with controller type (2)Firmware is not found
0x58 Bad block count of table is not match with number of scanned bad block
0x61 Rebuild Flash BAD Blk Failed
0x62 Autorun Image Error
0x64 Sensor Error
0x68 Erase Block Failed
0x72 Initialize ISP Failed
0x74 Check Disk Information Failed
0x78 Update Disk Information Failed
0x81 ISO Volume is exhausted
0x82 Flash Manufacture checking error
0x84 Sensor Get Image Failed
0x88 Run Disk Stress R/W Failed
0x91 Clear Hidden Blk Failed
0x92 Source folder doesn't exist or source file is missing
0x94 Check Disk MBR/FAT Failed
0x98 Format Disk Failed[localimg=29,91]1[/localimg]
0xa1 Size of source files is large than partition size during running
0xa2 Partition Setting Error
0xa3 Serial number out of range0xa4 Size of source files is large than partition size
IP卡
狗仔卡
发表于 2011-2-11 03:18:12
收藏
支持
反对
提升卡
沉默卡
喧嚣卡
变色卡
千斤顶
显身卡
楼主