关于NTBOOT.EXE这个程序 是从哪得到的?

chnhhwz

今天在深度郁闷了
写了个NTBOOT.EXE引导NTLDR作U盘PE的帖
结果有人说NTBOOT.EXE在XP中找不到 2003中也找不到 百度一找是病毒

偶自己去搜索 结果找到的全是病毒相关的资料

谁能说说 这个程序从哪可以得到?

flyingsand

时空论坛老大Gandalf的作品！

nndnnd

用这个吧，vista里面滴。

[ 本帖最后由 nndnnd 于 2007-5-1 05:12 PM 编辑 ]

emzt

vista下的bootsect怎么用?

阿非

原帖由 emzt 于 2007-5-23 08:57 PM 发表
vista下的bootsect怎么用?

/nt52   Applies the master boot code that is compatible with NTLDR to SYS,
        ALL, or <DriveLetter>.  The operating system installed on SYS, ALL, or
        <DriveLetter> must be older than Windows Vista.
/nt60   Applies the master boot code that is compatible with BOOTMGR to SYS,
        ALL, or <DriveLetter>.  The operating system installed on SYS, ALL, or
        <DriveLetter> must be Windows Vista or WindowsServer "Longhorn".
SYS     Updates the master boot code on the system partition used to boot
        Windows.
ALL     Updates the master boot code on all partitions.  ALL does not
        necessarily update the boot code for each volume.  Instead, this
        option updates the boot code on volumes that could be used as Windows
        boot volumes, which excludes any dynamic volumes that are not
        connected with an underlying disk partition.  This restriction is
        present because boot code must be located at the beginning of a disk
        partition.
<DriveLetter> Updates the master boot code on the volume associated with this
        drive letter.  Boot code will not be updated if either 1)
        <DriveLetter> is not associated with a volume or 2) <DriveLetter> is
        associated with a volume not connected to an underlying disk
        partition.
/force  Forcibly dismounts the volume(s) during the boot code update.  You
        should use this option with caution.
        If Bootsect.exe cannot gain exclusive volume access then the file
        system may overwrite the boot code before the next reboot.
        Bootsect.exe always attempts to lock and dismount the volume before
        each update.  When /force is specified, a forced dismount is attempted
        if the initial lock attempt fails.  A lock can fail, for example, if
        files on the target volume are currently opened by other programs.
        When successful, a forced dismount allows exclusive volume access and
        a reliable boot code update even though the initial lock failed.  At
        the same time, a forced dismount invalidates all open handles to files
        on the target volume.  This could result in unexpected behavior from
        the programs that opened these files.  Therefore, you should use this
        option with caution.
Example:
To apply the master boot code that is compatible with NTLDR to the volume
labeled E:, use the following command:
bootsect /nt52 E:

阿非

nt52为写入2000，XP.2003等老的NT引导，启动后引导 ntldr
格式为   bootsect /nt52 X:，X为你要写入NT引导的在WINDOWS 下的盘符。
nt60为写入VISTA引导，启动后引导 bootmgr，格式为
bootsect /nt60 X:，X为你要写入NT引导的在WINDOWS 下的盘符。